How To Clean Dryer Vent for Best Results
1.Disconnect Dryer Unit
- Before dryer vent cleaning, locate the vent, which should be easily found at the back or side the dryer. Also locate the dryer exhaust vent at your home’s exterior.
- First step of how to clean a dryer vent is to unplug the dryer. If you have a gas dryer, turn the supply valve off while cleaning.
- Pull the dryer away from the wall about a foot to begin cleaning your dryer vent.
- Disconnect the dryer duct from the back of the dryer. You may need to use a screwdriver to disconnect the vent clamp.
Many types of flexible dryer exhaust hose made of pvc plastic, vinyl or foil are more likely to become clogged and cause fires in your home, so replace them with ductwork that meets your local building codes. Learning how to clean a dryer vent
2.Brush-Vac Duct System
- The first step to cleaning a dryer duct is to feed the brush into the duct and move it back and forth while slightly rotating it.
- Extend the brush as needed and continue until the vents are free of dust and lint.
3.Use Powerful Vacuum Remove Loosened Debris
- If you can detach the length of duct where it meets the wall, do so. It will make cleaning it easier.
- Cleaning a dryer duct isn’t difficult. Remove lint from the duct by hand and then vacuum the inside of the duct. Use hose extensions, if available, to vacuum out as much of the duct as you can.
- Go outside the house and remove the exterior vent cover.
- Clean out the dryer vent from the outside using a vacuum.
- Roof dryer vents play a crucial role in the overall functionality of a home’s ventilation system. They are installed on the roof to allow hot and moist air from the dryer to escape
5.Connect Dryer Vent To Wall Securely.
- When finished cleaning, inspect the ducts to make sure they are undamaged and up to safety codes. Replace transition duct if needed.
- Reattach ductwork and vent screen. If necessary, seal sections of ductwork with UL-listed metal foil tape.
- Push the dryer unit back into place and plug it in/turn the gas valve back on.
- To test the dryer, run it for 10 to 20 minutes on the low or air dry setting to make sure all the connections are strong and to dislodge remaining debris from unit.
- This Completes Steps as to How To Clean A Dryer Vent